螺杆泵正确的启动步骤
Screw the right to start the steps
注意事项
Notes
1.G型螺杆泵开机前必先确定运转方向，不得反转。
1.G-type screw pump running pre-boot must first determine the direction, shall not be reversed.
2.G型螺杆泵严禁在无介质情况下空运转，以免损坏定子。
2.G is strictly prohibited without the media-type screw pump under air operation, so as to avoid damage to the stator.
3.新安装或停机数天后的G型单螺杆泵，不能立即起动，应先向G型单螺杆泵体内注入适量机油，再用管子钳板动几转后才可起动。
3. The new installation or down a few days later G-type single-screw pump, can not immediately start, should first G-type single-screw pump body into the amount of oil, and then pipe clamp plate start moving only after a few trips.
4.输送高粘度或含颗粒及腐蚀性的介质后，应用水或溶济进行冲洗，防止阻塞，以免下次起动困难。
4. Transport of high viscosity or containing particles and corrosive media, the application of water or solvent to wash, to prevent the obstruction, so as to avoid difficulties in the next start.
5.冬季应排队积液，防止冻裂。
5. In winter should be fluid line to prevent the Frost Crack.
6.G型螺杆泵使用过程中轴承箱内应定期加润滑油，发现轴端有渗流时，要及时处理或调换油封。
6.G the process of using bearing-type screw pump should be regularly lubricating the box and found that when the shaft there is seepage, a timely processing or exchange seals.
7.在运行中如发生异常情况，应立即停车检查原因，排除故障。
7. In the event of abnormal operation should immediately stop checking reasons, troubleshooting.
|
